enfr
Toute l'actualité

Actualités

Tous les forums

Forum

  • Salome-Meca usage 23/10/2020 | par Ioannis
    Hi JonasA, You should use, in theory, the POU_D_T_GD element, which is the Timoshenko element that works for large rotations/large displacements, so that you can have the catenary effect you are...
    En savoir +
  • Salome-Meca installation 23/10/2020 | par Meinke
    Hello, you teach me a lot zohir about the instalation, but all theses problems can be solutioned installing python before salome >>sudo apt install python It’s a prerequisite that is not...
    En savoir +
  • Salome-Meca usage 22/10/2020 | par sb1966
    Dear All, I confirm experiencing similar problem (CA 14.4) while simulating an excavation with five stages. The following was observed : 1. The IMPR_RESU operator with FORMAT=’RESULTAT’ was...
    En savoir +
  • Salome-Meca usage 22/10/2020 | par sb1966
    Hi, You can use POU_D_E element, which is a Euler-Bernoulli [i]Beam[/i] element [b]with axial stiffness. [/b] You can refer to i) Sec 4.6 of the book by JPA and ii) Doc U4.42.01. (AFFE_CARA_ELEM)...
    En savoir +
  • Salome-Meca installation 22/10/2020 | par GPSalachs
    Hello, is it possible to update the packages of Salome Meca / Code Aster ? I am working with the 2019 version. Is there a reference guide on how to do this pass ? Thank you in advance...
    En savoir +
pronet

ProNet

Cultiver et faire connaître la plus-value de Code_Aster Open source et de Salome-Meca
Lettre d'information
Lire les anciennes lettres d'information