#1 2021-09-30 11:25:19

APereira

Member

Registered: 2021-09-30

Posts: 29

Simulate seal compression

Hi,

I tried to simulate in 2D plan / plan strain, the compression of a seal by steel plate. I modelise the seal by a material "HYPER_ELAS" with parameters C10 & K, and my steel plate with a material "ELAS" with E and Nu. I use a non linear static analysis with a "HYPER_ELAS" behaviour. When I run the simulation I have an error showing up "Comportement Hyper Elas non détecté". If I modelise my 2 parts by the same material, either the HYPER_ELAS one or the ELAS, my simulation run correctly.

I don't know how to run simulation with 2 differents models of material. Does someone know how to do so ?

Best regards

sameer21101970

Banned

Registered: 2019-09-06

Posts: 354

Re: Simulate seal compression

you have define 2 behaviour one for steel ELAS and for seal Hyper Elas. you must have define 2 seperate volume mesh groups for steel and elas hyper .

APereira

Member

Registered: 2021-09-30

Posts: 29

Re: Simulate seal compression

Hi,
Thanks for your answer.

Yes of course, there were 2 mesh difined (mesh_1&mesh_2) and I grouped them with "ASSE_MAIL : Superpose" in a "Global_mesh" and I applied my meterials models on each mesh, and I study the "Global_mesh".
If I'm not clear enough do not hesitate to tell me, I can also show you the .comm

regards
Adrien

sameer21101970

Banned

Registered: 2019-09-06

Posts: 354

Re: Simulate seal compression

you are not getting me.

share .comm file and .med files

miib

Member

From: La Capanna Dello Zio Tom

Registered: 2021-03-23

Posts: 198

Re: Simulate seal compression

share .comm file and .med files

---

I ever used code_aster for study.
Code_Aster ??? is the Novacula Occami of the FEM world.
“Non è bene cercare di fermare il progresso della conoscenza. L'ignoranza non è mai meglio della conoscenza.” Enrico Fermi.