Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2021-09-30 03:21:19

jrubio
Member
Registered: 2021-09-30
Posts: 1

ERROR=Full job output should be available in the directory 'E:/

Hi everyone,

I developed a new file, generated the geometry and the model mesh. Then in Aster Study I assigned the necessary properties (from mesh to output). But to run the simulation in Code Aster it stops after 2 seconds and indicates a red circle and a message says: "Full job output should be available in the directory" I have made sure that the mesh file (.med) and output ( .rmed) are saved in the same folder.

I am using Salome Meca version 9.3.0 for Windows

Could you support me with any suggestions?

I add an image

Thanks!
Regards!


Attachments:
error.JPG, Size: 150.97 KiB, Downloads: 54

Offline