#1 2021-06-29 10:59:42

LouisB

Member

Registered: 2020-12-21

Posts: 12

ANSYS or FEMAP to SALOME Meca

Hello,

I've read that it was possible to export FEMAP or ANSYS Geometry/Mesh to import them in SALOME Meca but I haven't found the info that shows how to do it...

My question is : Is it really possible ? If yes, how can I do it ? Is there any documentation on it ? 

Regards

LB

Last edited by LouisB (2021-06-29 11:00:27)

Viktor.Vlaski

Member

Registered: 2015-10-16

Posts: 20

Re: ANSYS or FEMAP to SALOME Meca

You can use meshio (github.com/nschloe/meshio) for conversion of the mesh from Ansys or Femap (export to Nastran, Ansys or Abaqus first) to med-format

nicolas_p

Member

Registered: 2020-04-14

Posts: 86

Re: ANSYS or FEMAP to SALOME Meca

There is a module in salome_meca "MedConverter" to convert mesh from systus, abaqus or ansys to med format

jose01233

Member

Registered: 2021-02-12

Posts: 6

Re: ANSYS or FEMAP to SALOME Meca

Hello,
Do you know how to access to the MEDConverter Module? I can't find it.
Thank you,