Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2021-06-10 16:06:07

Fabrizio
Member
Registered: 2020-11-20
Posts: 32

User Subroutine

Hello, I hope you are well
I wanted to ask you, if you know if there are user subroutines(in Code Aster), as there are in ABAQUS.
as for example, in the link I show in the following link

!https://classes.engineering.wustl.edu/2009/spring/mase5513/abaqus/docs/v6.6/books/sub/default.htm


I hope you can help me
thank you very much

Last edited by Fabrizio (2021-06-10 18:31:19)

Offline

#2 2021-06-12 09:46:55

Irvise
Member
Registered: 2019-12-07
Posts: 65

Re: User Subroutine

Hi Fabrizo,

Code Aster is libre software, which means you have full access to all the code. You can modify whatever you want in there. You can take a look at the developer documentation to know more about this: code-aster.org/V2/doc/v14/en/index.php?man=D take a look into the "Introduction" documents.

Apart from that, CA allows users to define material subroutines directly.  See code-aster.org/V2/doc/v14/en/man_u/u2/u2.10.01.pdf and code-aster.org/forum2/viewtopic.php?id=25412

I hope that helps. Regards,

Fernando

EDIT: I just realized you are the same person of the forum thread that I posted smile Sorry about that.

Last edited by Irvise (2021-06-12 09:49:51)

Offline

#3 2021-06-14 19:44:48

Fabrizio
Member
Registered: 2020-11-20
Posts: 32

Re: User Subroutine

Hi Fernando, nice to meet you again. I am just writing a UMAT routine to develop a self consistent viscoplastic model and wanted to know what user routines were available in code aster.
Now I am going to look at what you recommend
Thank you very much!!!

Offline