#1 2021-05-16 04:07:02

sihaqqi

Member

Registered: 2018-05-11

Posts: 14

Salome Meca 2020 installation on Ubuntu

Hi

During installation of SM2020 on VMWare, I am receiving following issues, hence I cannot install. Can someone please help. Thanks

runSalome running on ubuntu
Searching for a free port for naming service: 2810 - OK
inside europlexus set env...
Searching Naming Service  +omniNames: (0) 2021-05-15 20:03:55.566248: -ORBendPoint option overriding default endpoint.
found in 0.1 seconds
Searching /Kernel/Session in Naming Service  ++Warning, no type found for resource "localhost", using default value "single_machine"
++++++Warning: this type (Study,objref) already exists, it will be ignored.
Warning: this type (SALOME_MED/MEDCouplingFieldDoubleCorbaInterface,objref) already exists, it will be ignored.
+ found in 4.5 seconds
Start SALOME, elapsed time :   4.9 seconds
****************************************************************
     Warning: module BLSURFPLUGIN is improperly configured!
     Module BLSURFPLUGIN will not be available in GUI mode!
****************************************************************
****************************************************************
     Warning: module HYBRIDPLUGIN is improperly configured!
     Module HYBRIDPLUGIN will not be available in GUI mode!
****************************************************************
****************************************************************
     Warning: module GMSHPLUGIN is improperly configured!
     Module GMSHPLUGIN will not be available in GUI mode!
****************************************************************
****************************************************************
     Warning: module NETGENPLUGIN is improperly configured!
     Module NETGENPLUGIN will not be available in GUI mode!
****************************************************************
****************************************************************
     Warning: module HexoticPLUGIN is improperly configured!
     Module HexoticPLUGIN will not be available in GUI mode!
****************************************************************
****************************************************************
     Warning: module GHS3DPLUGIN is improperly configured!
     Module GHS3DPLUGIN will not be available in GUI mode!
****************************************************************
th. 140119167537728 - Trace /home/A34370/smeca/yamm_build/V2020.0.1_universal_build/V2020_nopackage_universal/modules/src/GUI/src/LightApp/LightApp_Application.cxx [807] :
****************************************************************
     Warning: icon for Calculator is not found!
     Using the default icon.
****************************************************************

*** Abort *** an exception was raised, but no catch was found.
    ... The exception is:SIGSEGV 'segmentation violation' detected. Address 8

Last edited by sihaqqi (2021-05-16 04:07:28)

Ioannis

Member

Registered: 2016-04-01

Posts: 67

Re: Salome Meca 2020 installation on Ubuntu

Hi,
This message that you show is when you try to run Salome-Meca, that is after the installation has taken place.
You should get I suppose some errors during the installation of the software, which should have some hint about the issue.
If you can copy-paste the output in the terminal during installation maybe someone can help.
Other than that the warnings you see are typical and should not cause a problem.
Good luck,
Ioannis

---

Aether Engineering
- aethereng.com -