Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2020-08-28 06:31:11

marco.mueller
Member
Registered: 2020-01-16
Posts: 24

Arbitrary ABNORMAL_ABORT after solver calculation

Bonjour,

my DYNA_NON_LINE simulation runs fine, until the post processing starts and then stops at arbitrary points without error message:

- After the last iteration
- While CALC_CHAMP
- While IMPR_RESU (see attached case)

Two out of ten runs, in which I tried different number of time step size / simulation time (and thus file size) were successfully finalised. Unfortunately not just the smallest ones.

I'm using Salome-Meca 9.3.0 / CA 14.4 on Windows 10.

Has anyone seen this behavior before?

Regards
Marco


Attachments:
RunCase_3_Stage_1.zip, Size: 95.02 KiB, Downloads: 22

Offline

#2 2020-08-28 08:07:41

sameer21101970
Member
Registered: 2019-09-06
Posts: 247

Re: Arbitrary ABNORMAL_ABORT after solver calculation

if you can share mesh file.

message shows 0, means solver run is successful.

some problem with definition in cal champ.

send mesh file.

Offline

#3 2020-09-01 14:38:12

marco.mueller
Member
Registered: 2020-01-16
Posts: 24

Re: Arbitrary ABNORMAL_ABORT after solver calculation

Hi,

unfortunately I'm not allowed to share the mesh files.

Any other idea?

Offline

#4 2020-09-23 08:51:04

marco.mueller
Member
Registered: 2020-01-16
Posts: 24

Re: Arbitrary ABNORMAL_ABORT after solver calculation

Has nobody seen this before? To me it seems to be related to the MS Windows implementation.

Offline