Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2016-09-08 09:14:56

jeanpierreaubry
Guru
From: nantes (france)
Registered: 2009-03-12
Posts: 3,616

what means "il n y a pas de modèle dans la liste numdof .NUME.LILI !"

hello

when trying to perform a modal analysis the following is raised
what is the trouble?
note the model consist only of cable elements

 ASSEMBLAGE(INFO=2,
             CHARGE=(bloquage, ),
             CARA_ELEM=car_pou,
             NUME_DDL=CO(numdof),
             MODELE=modele,
             CHAM_MATER=materiau,
             MATR_ASSE=(_F(MATRICE=CO(rigidity),
                           OPTION='RIGI_MECA',
                           MODE_FOURIER=0,),
                        _F(MATRICE=CO(rigigeom),
                           OPTION='RIGI_GEOM',
                           SIEF_ELGA=pre,
                           MODE_FOURIER=0,),
                        _F(MATRICE=CO(masse),
                           OPTION='MASS_MECA',),
                        ),
             INST=0.0,)

#2      Calculs elementaires et assemblages               CPU (USER+SYST/SYST/ELAPS):      0.01      0.00      0.00
   
   !----------------------------------------------------------!
   ! <EXCEPTION> <ASSEMBLA_35>                                !
   !                                                          !
   !  il n y a pas de modèle dans la liste  numdof .NUME.LILI !
   !----------------------------------------------------------!
 

jean pierre aubry

Offline

#2 2016-10-03 08:46:34

thgue8
Member
From: Paris
Registered: 2010-06-03
Posts: 55

Re: what means "il n y a pas de modèle dans la liste numdof .NUME.LILI !"

I am no specialist, but maybe you could try dividing your command into several like in section 3.1 of u4.61.21  http://www.code-aster.org/V2/doc/defaul … .61.21.pdf
I believe the idea behind CO(numdof) is to create numdof from modele.
Then you should use numdof without the CO to build the mass matrix and others.

Best,
Thomas

Offline