Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2021-10-24 21:35:33

gordon13
Member
Registered: 2021-10-24
Posts: 2

Cannot see element in boundary condition creation page

Hi
When I try to create a boundary condition on a 3D mesh, the element doesn't show up in the element selection section.

I've created the groups in the geometry mode, then created them groups in the mesh mode, and I can see the faces that were selected as those groups.

However those groups don't show up when trying to assign the boundary condition.

Any ideas what could cause this to happen?

Offline

#2 2021-10-25 08:27:09

APereira
Member
Registered: 2021-09-30
Posts: 34

Re: Cannot see element in boundary condition creation page

What type of BC's do you use ? In Salome-Meca, BC's allow some type on mesh, sometimes only nodes, sometimes only elments, somethimes both etc ...

Offline

#3 2021-10-25 15:51:10

gordon13
Member
Registered: 2021-10-24
Posts: 2

Re: Cannot see element in boundary condition creation page

I've been trying to follow tutorials for the past few days and the groups would never appear in the Enforce DOF BD with LIASON (ENCASTRE).

Today after trying again, the faces do appear! I don't know what changed or what I did differently

Sorry to waste your time!

Offline