Atom topic feed | site map | contact | login | Protection des données personnelles | Powered by FluxBB | réalisation artaban
You are not logged in.
Hello, I am trying to model a screwed connection of an insulated panel to a steel stud, taking into account contact and friction, The loading happens over a 1 second period which I divided by 20 in the analysis. the strange thing is that the Analysis runs fine without failure, but the DEPL field contains nothing!! Apparently only Numpy nan's
Any help will be appreciated.
The Mesh and the command file can be downloaded here.
h ttps://drive.google.com/drive/folders/0B_j1F1j-vVyoSWV5SUVsVWlQZFk?usp=sharing
Please fix the intended space after the h in the link, otherwise the system wouldn't allow me to post it.
Regards
Humberto.
Last edited by Humberto (2017-05-16 19:25:25)
Offline
consider reading my book
freely available here https://framabook.org/beginning-with-code_aster/
Offline
Jean, Thank you so much!, I guess my problem is not CA, but ParaVis, Somehow If I plot the field DEPL I get a yellow image with no numbers even in the scale bar!
See attached pic.
I will wrestle with ParaVis, hopefully I can find the issue.
Humberto
Offline
maybe a screenshot of the complete Salome meca window would help
nevertheless why not ging a try at Gmsh that is where my image is coming from
consider reading my book
freely available here https://framabook.org/beginning-with-code_aster/
Offline
Thanks Jean, I figured it out, the problem was in my IMPR_RESU Command, I was not asking to write a particular instant, I fixed that and Got the expected results.
Thanks a lot.
Humberto.
Offline