Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2017-03-17 01:08:50

cramirez
Member
Registered: 2016-06-25
Posts: 94

command IMPR_TABLE

Hello, I wanted to know where the results of the IMPR_TABLE command are displayed

Offline

#2 2017-03-17 09:46:31

sébastien meunier
Member
From: EDF Lab Les Renardières
Registered: 2007-12-02
Posts: 287

Re: command IMPR_TABLE

Hello,

Normally, you should have a .resu file in astk corresponding to the UL 8. Results are stored in this file.

Regards


Sébastien Meunier - EDF Lab Les Renardières

Offline

#3 2017-03-17 17:48:48

cramirez
Member
Registered: 2016-06-25
Posts: 94

Re: command IMPR_TABLE

Thanks for your answer, you could also say that it is that of logical unit and that means the number 8

Offline

#4 2017-03-18 14:59:41

jeanpierreaubry
Guru
From: nantes (france)
Registered: 2009-03-12
Posts: 3,829

Re: command IMPR_TABLE

hello

please read my book and the docs things like that are explained in there

jean pierre aubry


consider reading my book
freely available here https://framabook.org/beginning-with-code_aster/

Offline

#5 2017-03-21 19:19:48

GuillermoBarraza
Member
Registered: 2016-05-24
Posts: 49

Re: command IMPR_TABLE

cramirez wrote:

Thanks for your answer, you could also say that it is that of logical unit and that means the number 8

The key word UNITE specifies where the file is going to be printed depending on the kind of data you have. Regarding the number, 8 is the default identifier for .resu files. If you are working with ASTK, logic units are useful to print results of the same type and store them in different files.

E.g. You are about to print two tables (IMPR_TABLE) and store the results in two different .resu files. The next thing you do is declare the logic unit in each table:

IMPR_TABLE(TABLE=table1,
                      UNITE=8,); #8 is .resu by default
IMPR_TABLE(TABLE=table2,
                      UNITE=9,); #9 could also be .resu if defined in astk

Regards,

Guillermo

Offline